© 2016 CBT Supply, Inc. US
Patent No. 7,509,912
Technical Support: 800-770-7042
8
... Install laptop safe
into cutout
• Press down on the back of the lid to open
the laptop safe without the gas spring
assist. Use your other hand to provide
counter pressure so opening is controlled.
Keep pressure on the lid like this to provide access
to the screw locations for making pilot holes and
installing wood screws to the 3 locations on the
back side of the laptop safe.
Use five #6 x 3/4
Black Oxide pan
head wood screws,
install at these
locations. Make pilot
holes first with 1/8”
drill bit.
Install locations 1and 3 first
• Holding the lid as pictured above, perform
these operations:
Make a pilot hole using 1/8” bit for
locations 1, 2 and 3.
Install screws for locations
1 and 3 first...
Install location 2 with a screw-
driver and seat the head to its
lowest profile.
Install locations 4 & 5
• To access installation locations, PULL the drawer to open the safe. Because the
gas spring is not attached, assist with your other hand by gently lifting the lid.
Use an 1/8” bit to drill pilot holes, then install wood screws in locations 4 and 5.
If the retaining screw sits too proud,
it could damage the lid.
DO NOT CLOSE THE LID UNTIL FULLY
SEATED FLAT.
