© 2016 CBT Supply, Inc. US
Patent No. 7,509,912
Technical Support: 800-770-7042
7
Step 4:
Mount the PULL Handle Latch Release
• Turn the desktop over to work from the underside.
• Align the template to the Center Line and secure with masking tape.
• Use 1/8” drill bit with depth gauge (masking tape used in photo) to
make pilot holes for PULL Handle
• Remove template from surface
• Place PULL Handle over pilot holes
• Secure with the smaller 5/8 # 8 black oxide
with Deep Thread (#10) pan head screws
Step 5:
Install laptop safe into cutout
• Turn the desktop over to work from the
top side
• Orient the laptop safe with the PULL
drawer access facing the user side.
• The gas spring ships hanging loose. Do
not attempt to attach the gas spring be-
fore the unit is installed into the cutout.
• Lower the unit into the cutout, but be
careful to not let your fingers get in the
way.
• The next step will
be to open the
laptop safe with-
out the gas spring
assist. This will
allow access to the
installation screw
locations.
• DO NOT INSTALL
THE GAS SPRING
YET!
