g
To put the new lamp module into the projector
1. Remove the new lamp module from its packaging.
2. Carefully place the lamp module into the projector using the handle on the top of the module.
Hold the lamp module vertically and guide it into its slot. Gently press the power end of the
lamp module against the projector to ensure the power plug makes contact with the projector’s
power receptacle.
N
N O T E
You should be able to place the lamp module into the projector easily without applying much
force.
3. Use the Phillips screwdriver to tighten the captive screws.
4. Carefully replace the lamp cover.
5. Connect the power cable to the wall outlet.
6. Press the
Power
button once on the remote control or ECP to confirm that the projector is
operating and that the lamp module is correctly installed.
7. Put the old lamp in a secure container, and handle it gently until you recycle it.
g
To finish the projector lamp installation
1. Turn on the projector.
2. Adjust the projector image if necessary (see
3. Access the service menu to reset the lamp hour counter (see
page).
4. Activate the projector’s alert e-mails and lamp warnings if they’ve been deactivated (see
on page 62 and
C H A P T E R 5
Maintaining your interactive whiteboard system
38
Содержание Board 600i5
