SMART-AVI CATXPro, Руководство по установке

Страница: 9 / 32

9
www.smartavi.com
Connecting the matrix
Now you are ready to connect the CATXPro,
Connect all the cat5 coming from the transmitters to the inputs of the CATXPro
Connect all the cat5 going to the receivers to the output
Connecting the the main unit, the CATXPro
Make sure the unit is powered off before connecting all the cables
Connecting all the Transmitters
1 Locate the RJ45 jacks on the back of the CATXPro,
2 Connect the CAT5 cable to the RJ45 and mark each cable with the number of the transmitter
3 REPEAT steps for all transmitters cables
Connecting all the receivers
1 Locate the RJ45 jacks on the back of the CATXPro,
2 Connect the CAT5 cable to the RJ45 and mark each cable with the number of the receivers
3 REPEAT steps for all receivers cables
After all connection are made, you can turn on the CATXPro, on the front on the units 2 leds will show normal operation
of the unit
Installation (continued)
Connecting the Control Communication Cable: RS-232
Each unit can be controlled by a RS-232 port connected from the back of the chassis. The SmartControlPro software
will be used to control the units.
1. Connect the RS-232 cable the control computer by connecting the female RS-232 connector into the male RS-
232 connector of the PC. Turn the side screws so that it does not accidentally become disconnected
2. Connect RS-232 cable connector to the male RS-232 connector on the back of the chassis.