SMART-AVI CATXPro, Руководство по установке

Страница: 22 / 32

22
www.smartavi.com
COMPUTER
IP ROUTER
SMTCP-2
RS-232
SERIAL
CAT5
CAT5
MATRIX SWITCH (NOT CONNECTED)
Connecting to the SMTCP-2 for the first time WITHOUT DHCP
The first time you connect the SMTCP-2, you will need to perform the following steps to set the initial
configuration. This includes establishing an HTTP connection and manually setting the IP address for the
SMTCP-2.
1.
Power off all devices.
2.
Use a female to male
Straight-Through
RS-232 (Serial) cable to connect
the SMTCP-2 to the computer.
3.
Use a CAT5 ethernet cable to connect the SMTCP-2 to a TCP/IP network
via a network router or other network connection.
4.
Power on the computer and run a terminal program such as Hyperterminal to open a serial connection
to the SMTCP-2 using the standard 9600 baud, 8, N, 1, None Flow Control configuration.
5.
While powering on the SMTCP-2, press and hold Shift-1 (exclamation) until a command prompt appears.
6.
Press enter to show the network configuration help screen as follows:
Command:
ÉÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ»
º Network Configuration help º
ÈÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍͼ
Enter a command followed by optional parameters
Commands are SET DHCP INFO RESET and QUIT/SAVE
SET command allows you to change the network configuration:
SI xxx.xxx.xxx.xxx = Set IP Address
(if IP address is not entered then DHCP is ENABLED)
SM xxx.xxx.xxx.xxx = Set IP Mask
SG xxx.xxx.xxx.xxx = Set Gateway Address
RN = Reset Network Params:
IPADDR = 192.168.0.2
IPMASK = 255.255.255.0
GATEWAY = 192.168.0.1
DHCP ON = Enable DHCP
DHCP OFF = Disable DHCP
INFO = Display network configuration
RESET = Factory reset
QUIT = Saves configuration and quits
SAVE = Same as QUITNOTE: the above IP address is for demonstration purposes only. Actual results
may be different.
7. Follow the instuctions to manually assign an IP address to the SMTCP-2.
8. See page 19 for instructions on how to connect to the SMTCP-2 via HTTP.
Controlling the CATXPro with the SMTCP module (continued)