Smalvic FI-64ET, Инструкции по установке, использованию и обслуживанию

Страница: 62 / 106

60
Maintenance and cleaning
ATTENTION
Disconnect the electric power supply before performing any
type of maintenance on the product
• Do not clean the appliance using steam cleaners.
• Do not use rough, abrasive materials or sharp metal scrapers
to clean the oven door, as they can damage the surfaces and
cause the glass to break.
• Do not use acid products (like anti-scaling agents) as they can
damage the enamelled parts.
• Turn off the heating elements, wait for the internal parts of
the oven to cool down before touching or cleaning them.
When cleaning with a wet sponge or soft cloth, take all due
care if the surface is hot as it will produce steam and you
will risk scalding yourself. Moreover, some detergents create
noxious fumes on contact with the heat.
The enamelled or stainless steel parts must be treated with
caution. Use water or specific products, accurately drying with
a soft cloth. In case of heavy deposits in the enamelled parts,
use a sponge (non-abrasive) dampened with warm water and
vinegar. Residual foods and dirt must be removed immediately.
It will make removing them easier if the internal parts of the
oven are cleaned while they are still warm.
ATTENTION
The symbols stamped on the appliance (e.g. around the
knobs) can be damaged if dirt remains for an excessively
long period on them.
Dirt residue must be removed immediately but use products
specifically for steel as other overly abrasive ones could cause
the symbols to fade.
Regularly check the state of the rubber gasket located around
the oven opening. If gasket damage is noted, contact the
nearest technical after-sales centre.
Removing/mounting the oven door
Open the door completely and insert a metal rod into both
hinges (not supplied). This must have diameter of approx. 3 mm
and be inserted into the hole indicated in the figure. Pressed
door model/
Moulded internal door model
Door model with profiles
Grasp the door with both hands on the sides down. Lift the door
slightly and remove the hinges from 2 locations. Pull the door
toward you to release the hinges from their seats.
To re-insert the door, operate in reverse order. With the oven
door fully opened, remove the two metal rod from hinges.
Close the oven door slowly and make sure that it has been
correctly inserted and aligned.
ATTENTION
With the door dropped, never remove the 2 metal rods that
hold the hinges locked.
Do not rest weights on the door or hang them on the handle,
they could damage the products, creating malfunctions
Moreover, do not use the oven until the oven door has been
re-mounted correctly.
Removing the glass inside the oven door
To make it easier to clean the door, you can remove the glass
inside it.
Important: To remove the internal glass, first remove the door
from the oven and position it on a stable surface.
Attention: do not use any type of bevelled or sharp tool, which
could break the glass or damage the door.
Pay attention to which way you place the glass surfaces, when
you put them back, as they cannot be turned around. If it is not
positioned correctly, this can affect the operation of the oven or
even damage the appliance seriously.
Moulded internal door model (removing the door
from the oven)
It is possible to use thin cylindrical objects (e.g. two coins with
diameter of approx. 25 millimetres and 2 mm thick). Insert them
between the enamelled door and the glass in the areas near to
the clips A which block the glass in the upper part of the door.
Press until you hear a “click”, which means that the clip has
come out. Now lift the glass and take it out.
The intermediate glass is found immediately below (in the
versions in which it is applied) and must only be removed by
qualified staff.