9
Changing the model memory is not possible if the Tx battery voltage is too low. See the INPUT POWER
section on page 4. It’s a good idea to keep a record of all settings in each memory as a backup in case
parameters in a particular memory are accidentally changed, etc.
MODEL MANAGEMENT
Shows basic information regarding the model setup
in the “Model” memory number at top-left. Move the
cursor up or down to select / change the function to
adjust, and press
ENTER
to adjust the function.
Name:
With the cursor on this line press
ENTER
.
The method for setting the model name is the same
as for entering the USER NAME as described on
page 7. The maximum number of characters is eleven. Press
ESC
when fi nished.
Model Type:
Press
to place the cursor on this line, and
ENTER
to highlight the selection. Press
or
to select the model type as airplane, helicopter, or quadcopter. Press
ENTER
to confi rm.
Model Copy:
To copy all parameters from one model memory to another, place the cursor at this
line and press
ENTER
. The “COPY FROM” page will show. Highlight the memory to copy FROM and
press
ENTER
. Now the “COPY TO” page will show.
Place the cursor over the memory number to copy TO, and press
ENTER
. The “COPY CONFIRM”
screen will show. To abandon the copy function as shown on-screen, highlight “NO” and press
ENTER
to return to the “COPY TO” screen. Press
ESC
to return to the “MODEL MANAGEMENT” screen.
Otherwise, press
to highlight “YES” and press
ENTER
. All settings that previously existed in the
receiving memory will be permanently erased. The display will return to the COPY TO screen. Return
to the “MODEL SELECT” screen to confi rm the copy function was successful by looking at the memory
that was copied “to”.
Model Reset:
Use this function to clear all parameters of any single memory
except model type
back
to factory defaults. Enter this screen, move the cursor over the memory to reset and press
ENTER
.
Select “NO” to cancel or “YES” to proceed with the reset, and press
ENTER
. The display will then
return to the “MODEL RESET” screen.
Wireless Transfer:
To transfer all parameters
of one memory in this transmitter to another Tactic
TTX850 transmitter, move the cursor to this line and
press
ENTER
. Press
or
to select “Send” or
“Receive”. Press
ENTER
, then
or
to select
the model number to send or receive data. Press
ENTER
to perform the function, or
ESC
to cancel.
WING TYPE
This is for setting the type of tail and wing confi guration for the model. Depending on the mixes used and
setup of the aircraft, it might be necessary to change the aileron, elevator, or rudder reversing settings to
achieve the proper throw directions for the model.
For best results, selecting certain tail or wing types might require some servos to be connected
to different outputs on the receiver (not the normal channel slots). The TTX850 will automatically
map all controls accordingly. See the servo connection charts in this section for details.
TAIL SETTINGS
“Normal” is the factory default setting for the “TAIL” type. Move the cursor over “Normal”, press
ENTER
then
or
to select from V-Tail, Delta (elevon), and 2 Elevator options. Press
ENTER
to confi rm the
selection. The charts below can aid in determining the preferred tail and fl ap setting for the model.
Model :OO
Name : Sensei SS1
Model Type : Airplane
Model Copy
Model Reset
Wireless Transfer
Model Management
Send
OO
Sensei SS1
Receive OO
Sensei SS1
Transferring .
Wireless Transfer
