15
Repeat these steps to set additional points on the graph as desired. A point for “H” is not marked on the graph,
but is the right-most end of the curve line. The vertical position of this point can be adjusted by moving the
cursor to the RATE percentage, pressing
ENTER
, then
or
buttons. Press
ENTER
when fi nished.
To clear any point on the graph, place the cursor on the RATE percent, move the throttle stick until the
graph’s vertical line intersects the point, press
ENTER
and then
CLEAR
.
A switch can be assigned to toggle between the linear curve (for starting the engine, etc.) and the user-
defi ned curve (for forward fl ight, stunts, etc.). Select the switch on the CTRL line.
The exponential control of the user-defi ned throttle curve (but not the linear curve) can be active or inhibited.
This will soften or make the transition of the throttle curve more smooth. Move the cursor next to the EXPO
line and toggle between “ACT” and “INH”. Press
ENTER
when fi nished.
THROTTLE CUT
Allows the throttle channel’s output to be quickly moved to a user-defi ned position by fl ipping a switch. This
is to reduce engine / motor power for safety reasons. Default setting is -100% (idle).
Select a switch to control the throttle cut function on the CTRL line. Press
ESC
.
The throttle cut function will only work when the throttle stick position is below the trig point. To set this point,
move the cursor next to TRIG but do not press
ENTER
. Move the throttle stick to the desired position that
will trigger the throttle channel to move to the cutoff position. The graph will move accordingly as will the
percent shown on the THRO line at bottom. Press
ENTER
. The arrow on the left will now move and mark
this selected trigger position.
Move the cursor to the CUT percentage, press
ENTER
and adjust this cutoff value by pressing
or
to the desired position for the throttle channel’s output to move to when the throttle cut function is activated.
This position will be marked by the arrow on the right. Press
ENTER
to confi rm this mark.
When the throttle cut switch is in the ON position and the throttle stick is positioned
above
the trigger mark,
reducing the throttle stick to the trigger mark will automatically drop the throttle channel to the throttle cutoff
mark. The throttle channel will remain in this position. To regain full control of the throttle channel, move
the control switch to the OFF position.
ADVANCED GYRO GAIN
This screen is for setting gain sensitivities if using a
stabilization gyro in the aircraft. Up to three sensitivity
adjustments can be set for a gyro’s X, Y, and Z axes
(if applicable).
For each respective axis, move the cursor to the rate
percentage at top and press
ENTER
. Adjust this value
to the desired gain sensitivity for this axis. Then move the cursor to the output channel “OUT.CH” selection
at bottom to set which channel that this sensitivity will control. A control switch can also be selected by
moving the cursor to the “CTRL” line at bottom and selecting a switch as explained earlier in the manual.
Once all gyro gain sensitivities are set press
ESC
to exit this screen.
NOTE:
The method for setting the various following mixer screens is the same for each mixer. Refer to the
instructions for the DIFFERENTIAL mixer screen for adjustment of all other mixer screens. Any difference in
any one mixer screen will be noted accordingly. Normal wing mixing is the factory default setting. Depending
on the mixes used and setup of the aircraft, it might be necessary to change the setting of the aileron,
elevator, or rudder reversing settings to achieve the proper throw directions for the model.
Gyro X Axis
OUT.CH: -
CTRL:-----
NORM:+0%
Gyro Y Axis
OUT.CH: -
CTRL:-----
NORM :+0%
Gyro Z Axis
OUT .CH: 5
CTRL:SB (1)
S P.0:+100%
S P.1:+75%
S P.2:+25%
Advanced Gyro Gain
