17
2AI1FL:
If this wing type was set, the fl ap channel can be mixed with the aileron, elevator, or back to
the fl ap. Set the mix percent for each channel to be mixed, for all switch positions that control the mix.
Do NOT assign a switch at the CTRL line to make the mix active at all times. Press
ENTER
when done.
AIR BRAKE SET
This function will allow you to defi ne the air brake position and activate it with a switch. It’s available only
when 1AI1FL or 2AI1FL wing types are chosen.
When the 1AI1FL wing type is selected the brake can be mixed to elevator and/or fl aps. Adjust each mix
percentage as needed. Select a switch to turn the mix on/off.
When the 2AI1FL wing type is selected the brake can be mixed with the elevator, aileron, or fl aps. Adjust
each mix as needed. Select a switch to turn the mix on/off.
PROGRAMMABLE MIXER
Up to six programmable mixes can be set, with one
channel being mixed to any one or more channels.
Control characteristics from the input channel will be
passed to the output channel(s), such as travel limits,
exponential, etc. The output channel will still be able
to function independently as if it were not mixed with
another channel, but once an adjustment is made to the
input channel a resulting change will be seen on the
output channel as well. The mix level can be adjusted by
percent. A switch can be assigned to turn this mix on/off.
Enter the mixer screen. Move the cursor to select which mix to set and press
ENTER
.
The top line will show the mix number, with the cursor over the input channel, and the output channel to the
right. Press
ENTER
and
or
to highlight and set the input channel.
The rate of the input channel to mix with the output channel can be adjusted for each the right and left side
of the input channel’s center position. With the cursor next to RATE L, set the desired mix percentage.
Repeat for RATE R. Note the curve on the display’s graph will adjust according to the percentages entered.
The amount of the input channel to be mixed can be offset by setting a percentage next to “OFFSET”.
Assign a switch to control the mix in the CTRL line as explained earlier. Repeat the above procedures for
each of the four mixes that are to be confi gured.
RF OUTPUT
The Rf output signal can be turned on or off. If changing any programming parameters in the radio, it’s
recommended to turn the Rf off so not to unnecessarily clutter the fl ying space with radio signals. Leave
the Rf output signal ON anytime the model is being controlled.
Enter this screen to perform a range check on the radio system, as fully explained on page 24.
TIMERS
Two timers are shown on the home screen, which can be confi gured in this screen. The timer at the top of the
homescreen is T1, and the bottom is T2. The timers can be set to count up or down, and can be controlled
by a user assigned switch. The timers can also be controlled by the throttle stick if desired.
ENTER
this screen and press
or
to move the cursor to the timer feature to adjust for each timer
as desired. Once in the proper place, press
ENTER
to highlight the value. Press
or
to adjust the
time as needed.
MIX1:
MIX2:
MIX3:
MIX4:
MIX5:
MIX6:
CH5
---
---
---
---
---
CH5
---
---
---
---
---
ACT
INH
INH
INH
INH
INH
SF
OFF
-----
-----
-----
-----
-----
->
->
->
->
->
->
Programmable Mixer
