6
6. ADJUST WATER FLOW
Flushometer is shipped with the flow control adjustment turned OFF.
A.
Disconnect Flushometer Solenoid connector from the Sensor Assembly. Pull on end connector to prevent damage to wires.
B.
Lift the Sensor Assembly Override Button up to access the activation assembly.
C.
Open water flow by turning activation assembly slowly COUNTERCLOCKWISE using adjusting tool and a screwdriver or a wrench.
MAKE SURE SOLENOID CONNECTOR GOES THROUGH THE CENTER
OF THE ADJUSTING TOOL TO AVOID DAMAGE TO THE CABLE.
!!! NOTE !!!
D.
Connect Flushometer Solenoid connector to the Sensor Assembly.
E.
Activate Flushometer by pressing the Override Button.
F.
Adjust Activation Assembly after each flush until the flow rate delivered properly cleanses the fixture (turn
CLOCKWISE
to lessen flow and
COUNTERCLOCKWISE
to increase flow).
MAKE SURE FLUSHOMETER SOLENOID CONNECTOR IS
DISCONNECTED FROM SENSOR ASSEMBLY EVERY TIME
BEFORE ROTATING ACTIVATION ASSEMBLY.
!!! NOTE !!!
THE FLUSHOMETER IS ENGINEERED FOR QUIET OPERATION.
EXCESSIVE WATER FLOW CREATES NOISE, WHILE TOO
LITTLE WATER FLOW MAY NOT SATISFY THE NEEDS OF THE
FIXTURE. PROPER ADJUSTMENT IS MADE WHEN PLUMBING
FIXTURE IS CLEANSED AFTER EACH FLUSH WITHOUT
SPLASHING WATER OUT FROM THE LIP AND A QUIET
FLUSHING CYCLE IS ACHIEVED.
!!! IMPORTANT !!!
THE ACTIVATION ASSEMBLY SHOULD NEVER BE OPENED TO
THE POINT WHERE THE FLOW FROM THE VALVE EXCEEDS
THE FLOW CAPABILITY OF THE FIXTURE. IN THE EVENT
OF A VALVE FAILURE, THE FIXTURE MUST BE ABLE TO
ACCOMMODATE A CONTINUOUS FLOW FROM THE VALVE.
!!! IMPORTANT !!!
Decrease Flow
Increase Flow
Pass Solenoid Cable
through to avoid damage
7. INSTALL WALL PLATE
Flushometer is shipped with the flow control adjustment turned
OFF
.
A.
Make sure retaining screw on bracket is fully tightened
B.
Slide Sensor Assembly all the way up.
C.
Align Wall Plate cut out with the window and Override Button of Sensor Assembly and push Wall Plate all the way in.
i.Make sure sensor window and button are sitting inside the wall plate cut out.
D.
Slide Wall Plate all the way down.
E.
Unscrew the retaining screw using supplied Allen key until it touches wall plate.
F.
Make sure Wall Plate doesn’t slide up.
A.
Retaining Screw
C.
E.
DO NOT UNSCREW ANYMORE ONCE SCREW
TOUCHES WALL PLATE.
!!! NOTE !!!
B.
UNDER NO CIRCUMSTANCES SHOULD THE SOLENOID BE
REMOVED OR ADJUSTED.
!!! NOTE !!!
1
2
