2. FINISH WALL AND INSTALL WALL BRACKET
A.
Reinstall mud guard onto the Flushometer using provided 2” (50 mm) long truss head screws
(qty:2) to protect components from cement.
B.
Finish Wall by cementing in place. Use the marks on mud guard to make sure finished wall is
between 2” (51 mm) and 3” (76 mm) from the center line of the pipe.
C.
Remove mud guard by removing the 2” (50 mm) long truss head screws and discard mud guard.
NOTE. WALL PLATE OPENING MUST BE OF 5.6” X 5.6” (142 X 142 MM)
D.
Install wall bracket onto flushometer using the four 2” (50 mm) long screws provided.
i. Make sure the wall-bracket snap clip is positioned in bottom left side of the bracket and the
wall-plate retaining screw is bottom right.
ii. Make sure the wall-bracket is positioned plumb and level before tightening the screws.
A.
C.
D.
Di.ii
Retaining
Screw
Snap Clip
B.
3
