6
4 Sec.
SENSOR RANGE ADJUSTMENT
12/24 LINE PURGE FEATURE
This feature will operate the faucet every 12 or 24 hours since last use, or if not
used, to prevent stagnant water conditions.
Default purge duration is two minutes.
Consult factory regarding other timing options.
Steps to activate purge line feature:
1. Activate IR: cover lower part of sensor window with a white card/paper until
LED fl ashes GREEN to confi rm program mode is active.
2. Cover lower part of sensor window once more with a white card/paper
for approximately 24 seconds (ignore LED indications during this period).
Release when requested program is reached. (See LED indications to right.)
FACTORY SETTING IS APPROPRIATE FOR THE MAJORITY OF APPLICATIONS AND SHOULD NOT REQUIRE RESETTING UNLESS UNDER EXTREME SITUATIONS.
A
C
B
C
D
IR activation (see page 5). To enter programming mode place
fi nger on IR-Click (covering bottom half of sensor) 1 time for
2 seconds and remove, GREEN light will come on. Then, place
fi nger 2 times then remove. Light on sensor should blink RED
to indicate programming mode.
Wait until
LED fl ashes
GREEN
A
Cover IR-Click (bottom half of sensor) until
LED fl ashes RED 4 times - hold IR-Click until
LED fl ashes 1 to 8 times from minimum to
maximum range. See diagram below. Release
when requested range is reached.
B
D
1x 2 Sec.
10 Sec.
Deactivate
...1x
Activate 12HR
...2x
Activate 24HR
Activate 48HR
...3x
...4x
touch
(bottom half)
1x
2x
3x
4x
5x
7x
8x
6x = factory setting
SENSOR RANGE ADJUSTMENT DIAGRAM
