4
4 - REMOVE LABEL FROM SENSOR
Remove Label from Sensor Window.
Adjust lever to set
temperature.
Activate Faucet by holding installation instructions approximately 1-1/2”
(38 mm) in front of the sensor window until red light appears, then
remove instruction sheet. Faucet will run for four (4) seconds and the
range will automatically adjust to its environment. Wait ten (10) seconds
after water shuts off before using faucet.
Activate Faucet and check for leaks. If faucet does not function, refer to
the Troubleshooting section of this instruction manual.
Optional – To fi x
temperature, set lever to
the desired position, then
remove lever and plug
hole with cap.
A
A
A
B
B
5 - ACTIVATE FAUCET
6 - SET AND FIX TEMPERATURE
Remove
before use
Sensor Label
