5
Close supply stop(s).
Loosen screw with hex
wrench and remove
cap.
Move battery retainer
tab away from battery.
Remove old battery.
Dispose of properly.
Wait 15 seconds before
installing new battery.
Open supply stop(s).
Replace cover and
tighten screw with
hex wrench.
Wait ten (10) seconds
before using faucet.
Insert a new 6V type CR-P2 lithium battery.
The RED LED will fl ash for one (1) minute.
Reinstall battery cover. If LED doesn’t
fl ash or if it just lights up, remove and
then reinsert the battery. If water fl ows
continuously after inserting the new battery
and opening the supply stops, wait 15
seconds, remove and then reinsert the
battery.
A
B
C
F
E
G
D
7 - BATTERY REPLACEMENT
SETTINGS
Note:
Replace battery when RED LED indicator fl ashes each time faucet is in
use or when faucet stops functioning.
IR-Click Feature
The IR-Click is a detector located in the sensor window
of the faucet spout that allows the user to place the
faucet into the following function modes: Continuous Run,
Temporary Off and Auto Set Range Adjustment.
To use the IR-Click, cover bottom half of sensor with fi nger,
wait 2 seconds for Green light, then remove fi nger. When
in programming mode, each touch of IR-Click will produce
a quick Green fl ash.
10 Sec.
Function
Press Button
LED Signal
Temporary OFF
(2 min)
1. 1 time for 2 seconds
2. 2 times (double push)
1. LED Green (1)
2. LED Red pulsating fl ashes
reset:
1 time or will reset
automatically after 2 mins
Continuous Run
2 min default setup
(adjustable from 1-20 min)
1. 1 time for 2 seconds
2. 1 time for 3-5 seconds
1. LED Green (1)
2. Water fl ows after releasing
reset:
1 time or will reset
automatically after 2 mins
Auto Set Range
Adjustment
Details Shown in Next
Section
1. 1 time for 2 seconds
2. 2 times (double touch)
3. 1 time for 4 seconds then
hold till requested range is
reached
4. Release
1. LED Green (1)
2. LED Red blinks
3. LED Red (1-8)
4. LED Green (1)
