Sleipner SEP50, Руководство по установке, Страница: 5 / 28

5
4522 15 2021
-
SEP50
MC_0122
Thruster Measurements
Measurement
code
Measurement description
mm inch mm inch
ID Internal tunnel diameter 140 5,51 140 5,51
H Motor Height 264 10,39 264 10,39
W Width 200 7,87 200 7,87
L Length 208 8,19 208 8,19
WD Water Depth 140 5,51 140 5,51
TL Minimum tunnel length 124 4,88 124 4,88
TL (recommended) Recommended tunnel length 152 5,98 152 5,98
T (min) Minimum tunnel wall thickness 5 0,20 5 0,20
T (max) Maximum tunnel wall thickness 7 0,28 7 0,28
*50
12v
*50
24v
*Valid for SE & SEP
MG_0079
TL
WD
H
W L
ID
T
Tunnel centre line
Propeller position will
vary with each thruster
model
The gear leg/ propeller(s) must
never extend out of the tunnel
Single Propeller
Failure to follow the considerations and precautions can cause serious injury,
damage and will render all warranties given by Sleipner Motor as VOID.
MC_0411
MC_0105
Considerations and Precautions for S-Link Systems
When installing an S-Link™ system DO NOT connect any other control equipment directly to the S-Link™ bus except original Sleipner S-Link™ products.
In case of connecting third-party equipment, it must always be connected through a Sleipner-supplied interface product.
Any attempt to directly control or connect into the S-Link™ control system without a designated and approved interface will render all warranties and
responsibilities of all of the connected Sleipner products.
If you are interfacing the S-Link™ bus by agreement with Sleipner through a designated Sleipner supplied interface, you are still required to install at
least one original Sleipner control panel to enable efficient troubleshooting if necessary.