16
2933
6
2021
-
SH 240 & SH 320
MG_0186
FWD
DRAIN
PORT A
PORT B
G
Motor to House Installation
EN
1. Install the motor onto the motor bracket ensuring both the couplings and the drive shafts have locked together. The motor must be installed
with the solenoid facing the control box.
(NB: depending on your coupling you may need to wiggle the motor into place. Ensure the connection
couplings are engaging correctly. Ensure the motor cable terminals are accessible for electrical installation later.)
2. Fasten the bolts holding the motor to the motor bracket with the above torque.
3. Check the drive shafts engage by rotating the propeller. It is required the propeller can rotate via hand power.
(NB: Rotating the propellers can be
hard because of the gear reduction and the motor.)
4. Apply the gear leg and propeller with anti-fouling designed for propellers. Do not apply to the propeller drive shaft, the anodes or the end of the
gear leg facing the propellers.
(NB: The motor must be covered to avoid dust from fabrication/ maintenance operation entering the motor or the solenoids. After fabrication
maintenance operations have ceased the cover must be removed before operating the thruster.)
MC_0173
!
Please refer to the graphic for special considerations relating to your model
!
MG_0185
Bolt tightening force (4x):
33 Nm (24 lb/ft)
Install the relevant motor and
other electronics according to
electrical instructions in the
manual
