1
4
SSSSS
AFETY
AFETY
AFETY
AFETY
AFETY
T
T
T
T
T
ESTING
ESTING
ESTING
ESTING
ESTING
T
T
T
T
T
HE
HE
HE
HE
HE
S
S
S
S
S
YSTEM
YSTEM
YSTEM
YSTEM
YSTEM
After steps 1 through 13 in the installation section have been completed
and you have confirmed the LCD remote is code matched to the Sled-
Start module, the system can now be tested.
Start by making sure the parking brake on the snowmobile is set and the
clutch guards and covers are in place. Be sure the bypass toggle switch
is set to ON (see picture 7) and the snowmobile handlebar kill switch is
not on. A flash from the headlight should follow confirming the command.
You will hear the ignition and fuel pump kick in followed by the starter
cranking and starting the engine. The LCD remote will confirm a successful
start by a three-note music tone and the exhaust cloud will appear. Press
"S" again to shut the engine off. Next the ignition and the SledStart mod-
ule will shut down along with three shut down tones from the LCD trans-
mitter.
Once the engine is off turn the bypass toggle switch to the OFF position
- see picture 7
. Press the "S" button on the LCD remote. The snowmo-
bile should NOT start. Next remove the clutch cover that operates the pin
switch. DO NOT REMOVE TOP CLUTCH GUARD! Turn the toggle switch
back to the ON position. Be sure all body parts are clear of the clutch
area. Stand away from the clutch area and press the "S" button on the
LCD remote. The snowmobile should NOT start.
If the snowmobile starts in either the toggle or pin switch test CEASE USE
IMMEDIATELY and review the installation pages. Be sure these two
switches function properly. Before each ride check the safety system to
insure proper operation. If the clutch pin safety switch becomes rusty over
time, it may not make proper ground causing it not to work properly. If
needed please replace this switch so your safety system is fully function-
ing. Replacement switches can be found at www.sledstart.com.
P
PP
PP
ROGRAMMING
ROGRAMMING
ROGRAMMING
ROGRAMMING
ROGRAMMING
M
M
M
M
M
ODE
ODE
ODE
ODE
ODE
This section will be divided into two parts and will guide you through the
various settings the SledStart Remote Starter System offers.
Part 1 will describe how to select either Sound or Vibrate for the LCD re-
mote, LCD Backlight ON/OFF, using the Temperature/Auto Start feature,
setting the engine crank time, selecting Fahrenheit or Celsius modes, and
adjusting the clock.
Part 2 will describe the Features and Options section of the Programming
Mode.
