5. Locate one of the D-rings attached to the upper edge of
the Netting. Lift the D-ring and hold it close to an L-tube
(7) as shown in Inset Drawing A. Insert one of the Straps
(11) through the D-ring on the Netting (10). (See Inset
Drawing A). Next, thread the end of the Strap under the
Foam Sleeve (9) on the L-tube (7) and up through the
two D-rings on the opposite end of the Strap (11). (See
Inset Drawing B.) Then thread the end of the Strap (11)
back down through the lower D-ring on the Strap. (See
Inset Drawing C.) Pull the loose end of the Strap to
remove any slack but do not fully tighten the Strap (11)
at this time.
Attach the Netting (10) to the other three L-tubes (7) with
the other six Straps (11) in the same manner.
6. Tighten the seven Straps (11) attaching the Netting
(10) to the L-tubes (7). (See Step 4.)
Tie the free end of each Strap (11) around the rest of the
Strap (11) to prevent the Strap from becoming loose.
7. Tighten the Straps (11) (not shown) on the underside
of the frame pad. See Trampoline manual page 14.
8. Now insert the end cap (13) into the bottom of the T-
Bracket.
Your trampoline enclosure is now fully assembled (put
together). Make sure that all parts are securely attached.
Familiarize yourself and all users of the trampoline and
enclosure with the safety precautions, use and instruction-
al materials, and care and maintenance instructions in this
manual before using the trampoline and enclosure.
10
Inset Drawing A
B
C
6. Align Enclosure door under one of the enclosure
uprights. Center the opening over leg post. Button on
Enclosure frame to each "V" spring clip. Remove spring.
Place "V" clip through button slot and re-attach spring.
Continue for all 64 springs and buttons.
