ASSEMBLY
IMPORTANT ASSEMBLY INFORMATION
Need phillips screw driver and 2 adjustable wrenches (putting the trampoline together). A rubber mallet may make assembly
easier, however.
Assembly requires two persons.
Wear gloves to protect your hands from pinch points during assembly.
TRAMPOLINE PLACEMENT
1. Place the trampoline on a level surface before using it.
2. Adequate overhead clearance is essential. A minimum of 24 feet from ground level is best. Provide clearance for wires, tree
limbs, and other possible hazards. Lateral (sideways) clearance is also essential. Place the trampoline away from walls, struc-
tures, fences, and other play areas. Always have a clear space on all sides of the trampoline.
3. Use the trampoline in a well-lighted area. Electric lights may be required for shady areas.
4. Secure the trampoline against unauthorized and unsupervised use.
5. Remove any objects from beneath the trampoline.
6. The owner and supervisors of the trampoline are responsible to make all users aware of practices specified in this manual.
1. Make sure that you understand the information in the box at the top of this page.
Lay one Top Tubes with"T"-Joint (1) and one Top Tube with
socket (8) (A and B in the inset drawing) on the ground in the
positions shown. Make sure the Top Tubes are turned so the
small holes (spring holes) are facing the ground.
Insert one end of the Top Tube with "T"-Joint(A) into the
socket of other Top Tube with socket (B). The Top Tubes with
Sockets and "T"-Joint should now appear as shown in step 2.
2. The peak of the Leg Brace (2) should point toward the
ground.
11
8
Insert one Leg Extension (7) into the Leg Brace (2) secure
with screw (9). Insert another one Leg Extension (7) into Leg Brace
(2) secure with screw (9). Insert one Leg halfway into the other
T-joint. Pull out on other leg and insert into other tube with
Socket. Press down on both Legs at the same time and fully insert
the T-joint tightened and Socket by screw (9).
them into
8
.
.
.