3.
Note: This step requires two persons
. During this
step, you will connect the four assembled leg sections
Stand two leg sections and hold them in the positions
shown.. Insert the small end of the Top Tube into the
indicated Top Tube with "T"-Joint (1) on the other leg
section. Repeat this step until all four leg sections are
connected. When this step is completed, the frame will be
fully assembled and freestanding.
4. Lay the Bed (Mat) (3) on the ground inside the assem-
bled frame. Make sure that the two warning decals (not
shown) are on top of the Bed (Mat). (Not Shown.)
Your safety enclosure net is pre-installed. Inspect the
attachments of the enclosure Netting to the trampoline
mat (bed). Make certain each of the V-rings on the tram-
poline mat (bed) is threaded through the corresponding
"buttonhole" in the Netting. Be sure to place the opening
in the Netting so it is centered under the arch where the
jumpers will climb off of and onto the trampoline.
Note: There are 64 V-rings around the edge of the Bed
(Mat) (3) and 64 holes around the top of the frame. In
Steps 4 and 5 you will attach the Bed (Mat) (3) to the
frame, using 64 Springs (4).
Caution: It is wise to wear leather gloves while attach-
ing the Springs. Be careful where you place your
hands as the Springs and frame joints can pinch.
Position the Mat/Enclosure opening as shown (A).
12
Diagram A
