ASSEMBLY
ASSEMBLY (PUTTING THE ENCLOSURE TOGETHER)
IMPORTANT ASSEMBLY INFORMATION
• Need phillips screw driver and 2 adjustable wrenches (not included).
• Assembly requires two adults. Keep children away from the trampoline enclosure until it is completely put together.
• Use gloves to protect your hands from pinch points while putting the enclosure together.
• Make sure that the trampoline is properly put together, with the frame pad correctly laid out, before you put together the tram-
poline enclosure.
• The assembly steps refer to parts by their descriptions and key numbers (see the PARTS LIST on page 13 and make sure that
all listed parts are included. If a part is missing, refer to ORDERING REPLACEMENT PARTS at the bottom of page 13.
TRAMPOLINE PLACEMENT
1. Place the trampoline and enclosure on a level surface before you use it.
2. Adequate overhead clearance is essential. A minimum of 24 feet (7.3 meters) from the ground is recommended. Provide clear-
ance for wires, tree limbs, and other possible hazards. Lateral (sideways) clearance is also essential. Place the trampoline and
enclosure away from walls, structures, fences, and other play areas. Maintain a clear space on all sides of the trampoline and
enclosure.
3. Use the trampoline and enclosure in a well-lighted area. Artificial (electrical) lighting may be required for shady areas.
4. Secure the trampoline and enclosure against unauthorized and unsupervised use.
5. Remove any objects from under the trampoline and enclosure.
6. The trampoline enclosure is only to be used as an enclosure for a round trampoline.
1. Make sure that you understand the information in the box at the top of this page.
2. Lay two Straight Tubes (6), two L-tubes (7), and a
Curved Tube (8) on the ground so they form an arch.
Make sure that the Straight Tubes are oriented so the
small holes are in the positions shown. The frame
should be completely assembled with the screws.
Then carefully slide the foam sleeves onto the
frame.(9). Note: The ends of the Straight Tubes
should not be covered.
Insert the two L-tubes (7) into the two Straight Tubes
(6). Next, insert the two L-tubes into the Curved
Tube (8).
Tighten four Self-tapping Screws (5) into the small
holes in the Straight Tubes (6) and the Curved Tube
(8). Note: The Small holes may be on the opposite
side of the Curved Tube.
Assemble (put together) the remaining Straight
Tubes, L-tubes, Curved Tubes, and Foam Sleeves in
the same way.
6
9
7
5
Small
Hole
Small
Hole
9
5
8
9
5
9
5
7
9
6
8
