7
5
V-ring
Frame
Attach the Springs (7) as follows: Hook one end of a
Spring (7) into a V-ring. (See the inset drawing.) Hook a
second Spring (7) (not shown) to the free end of the first
Spring (7). Use the second Spring to pull the first Spring
until it reaches the frame. Push the end of the first Spring
into a hole in the frame. Unhook the second Spring.
After you have hooked one Spring (7) into one of the V-
rings on the Bed (Mat) (5), count exactly 20 V-rings and
20 frame holes in a clockwise direction. Attach a second
Spring to the V-ring and frame at this point. Count 20 V-
rings and 20 frame holes in a clockwise direction and
attach a third Spring. Count 20 V-rings and 20 frame
holes in a clockwise direction and attach a fourth Spring.
5. After attaching the first four Springs (7), count exactly
10 V-rings and 10 frame holes in a clockwise direction.
Attach another Spring to the V-ring and frame at this
point. Count 20 V-rings and 20 frame holes in a clock-
wise direction and attach another Spring. Count 20 V-
rings and 20 frame holes in a clockwise direction and
attach another Spring. You will now have 8 evenly
spaced Springs (7) attaching the Bed (Mat) (5) to the
trampoline frame.
Attach eight Springs (not shown) evenly between the
eight attached Springs in the same manner as before.
Attach sixteen Springs (not shown) evenly between the
sixteen attached Springs.
Continue to attach the remaining Springs between the
previously attached Springs until all Springs are attached.
Safety Note: For the Bed (Mat) (5) to have the even ten-
sion necessary for safety in jumping, the Springs (7) must
be attached as described. As you attach Springs, carefully
count the V-rings and frame holes. If a V-ring or hole is
skipped, reattach the Springs in the proper position.
6. Lay the frame Pad (6) on the frame. Adjust the posi-
tion of the Frame Pad so that the slits are directly above
the Legs (3), as shown.
(If you are using the Skywalker Trampoline Enclosure,
go to the Skywalker Trampoline Enclosure User’s
Manual, pages 8-11, for instructions in assembling the
Enclosure. The Enclosure must be assembled and secured
to the trampoline frame before proceeding further with
trampoline assembly.)
5
7
7
7
7
V-rings
Align opening of enclosure
as shown here, centered in
between the legs of the
trampoline.
Slit
3
6
13
Inset drawing
