Skytrofa Auto-Injector, Инструкция по эксплуатации

Страница: 10 / 35

2
How to Use
17 16
Prepare
Turn on the auto-injector
2.1 Disconnect the auto-injector from the
charger when charged.
•
The auto-injector cannot be used
when connected to the charger.
2.2 Find a quiet place where you can give
your injection.
2.3 Remove the protective cover. Place the
auto-injector upright on a flat surface.
2.4 Press and release the green button to
turn on the auto-injector
(see Figure H).
•
You will hear a humming sound. The
battery icon and the 3 icons above
the green button will light up. Then
all of the icons will turn off, except
the battery icon.
Press and
release the green
button to turn on
the auto-injector.
(You will hear 2
loud beeps.
Battery icon
will light up and
green top will
start flashing)
Figure H
•
You will hear 2 loud beeps and the
green top will start flashing. The
auto-injector is ready for use.
•
If the auto-injector is not active for
6 minutes, it will turn off. Press the
green button to turn it on again.
2.5 Check the battery icon on the base
of the auto-injector to see if it is
charged. The battery icon is green
when the auto-injector is ready to use:
Constant Green
Battery is fully charged.
The auto-injector is ready to use.
Flashing Green
At least 1 injection remaining, but
charging is recommended after
use.
Flashing Red
Battery needs charging.
If no icons light up
b
page 44.
If you see flashing icons (other than the battery)
b
pages 46–47.