Skytech: RCT-MLT-IV
REV. 3-26-19 Page 1
MODEL: RCT-MLT IV
INSTALLATION AND OPERATION INSTRUCTIONS
IF YOU CANNOT READ OR UNDERSTAND THESE INSTALLATION INSTRUCTIONS DO
NOT ATTEMPT TO INSTALL OR OPERATE
INTRODUCTION
This remote control system was developed to provide safe, reliable, user-friendly remote control system for gas appliances. It is a dry
contact thermostat system that can manually operate fan speed and flame height from the transmitter.
The transmitter operates on (2) AAA 1.5V batteries that are included. Install the AAA
batteries supplied with the unit into the battery compartment. It is recommended
that ALKALINE batteries always be used for this product.
Be sure the batteries are
installed with the (+) and (-) ends facing the correct direction.
If the transmitter does not illuminate when you press any buttons, or you see nothing
on the LCD screen, check the position of the batteries.
TRANSMITTER
MODE
TIME
TIMER
SET
DOWN
UP
+
+
-
-
FAN
FLAME
LIQUID CRYSTAL DISPLAY - LCD
ON
OFF
THERMO
X
ROOM
SET
AM
PM
TIMER
FLAME
E
E
1
2
3
4
5
6
7
8
TIMER
AME
LA
FAN
HI
MED
LOW
OFF
9
1. Low Battery Indicator -
Battery power is low, replace batteries within two weeks.
2. Timer -
Time remaining before the system shuts off, must be programmed.
3. Mode -
Indicates whether the system is ON, OFF, or in THERMO mode.
4. Set -
Indicates the desired SET temperature when in THERMO mode.
5. Flame -
Indicates burner/valve operational.
6. Clock -
Indicates current time.
7. Room -
Indicates current ROOM temperature.
8. ºF -
Indicates degrees Fahrenheit (ºC indicates degrees Celsius).
9. Fan -
Indicates the fan is ON, or is programmed to come ON.
MODE FUNCTION
To select an operational mode, press the MODE button on the transmitter.
ON -
Turns the appliance ON, the flame icon will appear on the LCD screen.
THERMO -
Remote is in THERMO mode.
OFF -
Turns the appliance OFF, the flame will disappear from the LCD screen.
SETTING ºFAHRENHEIT / ºCELSIUS SCALE
+
+
-
-
SETTING
BUTTON
The factory setting for temperature is degrees fahrenheit (ºF). To change this
setting to degrees Centigrade (ºC):
•
Remove battery cover on the back of the transmitter and locate the setting
button in the top center of the battery compartment.
•
Push the button once to enter temperature scale setting mode.
•
Use the up and down buttons to switch between the ºF and ºC.
•
Push the setting button again once again to set the displayed temperature
scale.
•
Repeat this procedure to switch back to ºF.
E474962
