PROGRAM STEP 4:
Activate the program.
1 => Press the
[MODE]
button to enter THERM Mode (screen will display
THERMON
or
THERMOFF
, depending on your
cool target temperature and current room temperature.
2=> Press the
[PROG]
button and the word
PROGRAM
will appear in the lower display along with P1 or P2, depending
on the current time of day.
To override the program
, press the
[MODE]
button to put the remote in manual ON mode. When the user turns the
remote back to THERM mode, the remote will resume regular program mode (the word PROGRAM will appear above
the display time).
To turn the program function off, press the
[PROG]
button. The word PROGRAM will disappear from the LCD screen.
WARNING
THIS REMOTE CONTROL SYSTEM MUST BE INSTALLED EXACTLY AS OUTLINED IN THESE INSTRUCTIONS. READ ALL
INSTRUCTIONS COMMPLETELY BEFORE ATTEMPTING INSTALLATION. FOLLOW INSTRUCTIONS CAREFULLY DURING
INSTALLATION. ANY MODIFICATION OF THIS REMOTE CONTROL OR ANY OF ITS COMPONENTS WILL VOID THE WARRANTY
AND MAY POSE A FIRE HAZARD.
GENERAL INFORMATION
MATCHING SECURITY CODES
Each transmitter can use one of 1,048,576 unique security codes. It may be necessary to program the remote receiver to
LEARN the security code of the transmitter upon initial use, if batteries are replaced, or if a replacement transmitter is
purchased from your dealer or the factory. Refer to
STEP 4
.
The microprocessor that controls the security code matching procedure is controlled by a timing function. If you are
unsuccessful in matching the security code on the first attempt, wait 1-2 minutes before trying again – this delay allows
the microprocessor to reset its timer circuitry – and try up to two or three more times.
THERMO FUNCTION
When the transmitter is in the THERMO mode, it should be kept away from direct sources of heat such as fireplaces,
incandescent lighting, and direct sunlight. Leaving the transmitter in direct sunlight, for example, will cause its heat-
sensing diode to read the room temperature higher than it actually is; if in THERMO mode, it may not turn on the
appliance even if the ambient ROOM temperature is below the SET temperature.
BATTERY LIFE
Life expectancy of alkaline batteries in the
remote
should be at least 12 months. Check and replace all batteries
annually. When the Transmitter no longer operates the receiver from a distance it did previously (i.e., the transmitter’s
range has decreased) or the remote receiver does not function at all, the transmitter batteries should be checked. The
Transmitter should operate with as little as 5.0 volts of battery power, measuring at the (4) 1.5-volt batteries.
Содержание RC-AA-PROGR
Страница 8: ......
