SETUP STEP 5: Set
o
F /
o
C Scale
The factory setting for temperature is ºF. To toggle between ºF and ºC, simultaneously press and hold the
UP and
DOWN
icons on the touchscreen.
NOTE:
When changing between the ºF and ºC scales, the set temperature defaults to
the lowest temperature (45 ºF, or 6 ºC).
SETUP STEP 6: System Check
Each click of the
[MODE]
button will toggle the remote control through the 3 operation modes: ON, OFF, and THERMO.
To toggle to the ON mode, click the
[MODE]
button on the transmitter. If THERMON, THERMOFF or OFF is displayed at
the top of the LCD screen, click the
[MODE]
button 1 – 2 more times until the word ON appears in the top left corner of
the display. The appliance should turn on. If the appliance does not turn on, go back to SETUP STEP 1.
SETUP STEP 7:
Set the current date and time.
Press and hold the
[SET]
button for 5 seconds. The hour section will begin to flash.
Use the
UP
&
DOWN
icons on the touchscreen to select the hour, then press the
[SET]
button.
The minutes will flash. Use the
UP
&
DOWN
icons on the touchscreen to select the minute, then press the
[SET]
button.
AM PM will flash. Use the
UP
&
DOWN
icons on the touchscreen to select AM or PM, then press the
[SET]
button.
One of the days of the week will flash (above the clock). Select the correct day by pressing the
UP
&
DOWN
icons on the touchscreen then press the
[SET]
button. Your time will automatically be accepted.
Understanding the Communication Safety Shutoff Function / What to do if the receiver beeps
This remote control has a COMMUNICATION –SAFETY function built into its software. It provides an extra margin of
safety when the Transmitter is out of the normal 20 foot operating range of the receiver.
At all times and in all OPERATING MODES, in addition to the THERMOFF or THERMON signal that is sent every 2 minutes,
the transmitter sends an RF signal every 15 minutes to the receiver indicating that the transmitter is within the normal
operating range of 20 feet. Should the receiver NOT receive a transmitter signal every 15 minutes, the receiver will
begin a 2 hour (120 minute) countdown timing function. If during this 2-hour period, the receiver does not receive a
signal from the transmitter, the receiver will shut down the appliance being controlled by the receiver. The receiver will
then emit a series of rapid “beeps” for a period of 10 seconds. Then after 10 seconds of rapid beeping,
the receiver will
continue to emit a single “beep” every 4 seconds until a transmitter [MODE] button is pressed to reset the receiver.
Understanding the Thermo-Safety Feature
PROTECTION FROM EXTREME HEAT IS VERY IMPORTANT. Like any piece of electronic equipment, the remote receiver
should be kept away from temperatures exceeding 130
0
F. Exposure to extreme temperatures can damage the electronic
components or cause the plastic case to become deformed and is not covered under warranty. A receiver located in an
area, where the ambient temperature inside the case exceeds 130
0
F, will cause THERMO-SAFETY feature to activate and
sound warning beeps.
To reset the receiver and stop the warning beeps,
reposition the receiver away from the heat.
Содержание RC-AA-PROGR
Страница 8: ......
