Remote Control Power Settings
(SKY-MRCK, SKY-MRCK-TH, SKY-CON, & SKY-CON-TH)
The electronics in this remote control system have the capability of powering two (2) different types of DC powered
components, they are as follows.
On the SKY-MRCK & SKY-MRCK-TH receivers come from the factory programmed to provide
continuous
DC voltage
(4.5 VDC to 6.0 VDC) to a gas valve with a servomotor when the OFF/Low or On/Hi buttons on the transmitter are
depressed. (This is referred to as the 1001SR Setting in the Power Setting section of the remote control section of the
installation instructions)
On the SKY-CON & SKY-CON-TH receivers come from the factory programmed to provide a
pulse
DC voltage (4.5
DCV to 6.0 DCV) to a gas valve that uses a latching relay or solenoids when the OFF or On buttons on the transmitter are
depressed. (This is referred to as the 1001P Setting in the Power Setting section of the remote control section of the
installation instructions)
If the receiver on the SKY-MRCK or SKY-MRCK-TH is set incorrectly set to the 1001P setting this will cause the
servomotor to only operate each time the transmitter button is depressed.
(STOP/START/STOP/START)
If the receiver on the SKY-CON or SKY-CON-TH is set incorrectly set to the 1001SR setting this will cause the latching
relay-solenoid not to operate when the transmitter button is depressed.
POWER SETTING
To change the factory “power setting”, from the 1001SR to the 1001P setting, first load the RECEIVER with 4-AA
batteries as instructed in the REMOTE RECEIVER SECTION; that follows.
1.
Slide the slide switch on receiver to the REMOTE position.
2.
Push and hold in the LEARNING BUTTON on the front of the receiver. You will hear a continuous “beep
sound” for about three seconds. Continue to hold in the LEARN button, the “beep sound” will stop for about four
seconds and then a second “beep sound”, of a different pitch, will be heard. The conversion from the 1001SR
setting to1001P setting is complete.
3.
To reprogram RECEIVER to the 1001SR setting, repeat process and receiver will reset to 1001SR setting.
4. The LEARN button is used to set the unique security code for your remote control system. The SECURITY
CODE is reset during the “power setting” process.
Rev. 8/2007 Page 1
