TROUBLE SHOOTING FOR RCAF-LMF/V
1.
Make sure new or good batteries are installed properly in the transmitter and receiver. Make sure that transmitter
is within the 20’ – 25’ range of the receiver.
RCAF-LMF/V
Transmitter Battery Compartment
2.
Check to make sure the transmitter is communicating with the receiver.
•
If the receiver beeps when the “ON/HI” or “OFF or LO” buttons are depressed on the transmitter then
the transmitter is talking to the receiver.
•
If the receiver does not beep when the “ON/HI” or “OFF/LO” buttons are depressed on the
transmitter, you will need to “LEARN” the transmitter and receiver.
“LEARN”:
•
Press and release the “LEARN” button, you should hear a “BEEP”.
•
Then push the “ON/OFF” button within 5 seconds; you should hear several “BEEPS”.
3.
To check this unit for proper operation, check the following:
•
To check the receiver use a multmeter and set it to DC volts, connect the leads to the outlet block on
the receiver, when you depress the “ON” or “OFF” buttons you should read about 6.4 DC volts Max.
If the voltage is less than 4.0 volts you should replace the receiver batteries.
4.
Make sure that the receiver is not installed in or behind an enclosed metal chamber or door, or in an area that
exceeds 130 degrees F.
•
This condition can cause the RF signal to get lost and not communicate with the receiver.
•
This condition will also cause the working distance to be shorter than normal.
•
Areas that exceed 130 degrees F will cause the battery life to be short and the heat will damage the
receiver. This is not a warranty condition.
5.
If the valve isn’t opening or closing, check to see if you can open or close it with a 9-volt battery.
•
Take the receiver wires off of the motor drive.
•
Take your 9-volt battery and put your positive (+) to one terminal and your negative (-) to the other,
this should drive your motor HI or LOW. To go the other way, turn the battery the other way.
6.
Contact Skytech Systems, Inc. customer service at 888.672.8929 if you need additional information.
Rev. 4/2011 Page 1
