Skytec 151.557 Triton, Инструкция по эксплуатации

Страница: 4 / 26

4
10. Microphone
11. Mode button
12. Enter button
13. Up button
14. Down button
15. LED display
After you connected the Triton scanner to the mains (8) and switch on the unit the Triton LED scanner starts
running. During the reset the motors are trimmed and the device is ready for use afterwards.
The Triton has 3 operations modes. It can be operated in
DMX, Slave or master mode. The mode can be selected
by pressing the mode button (11).
Master-Slave Operation:
This function will allow you to link up to 4 units together
and operate without a controller. The units will be sound
activated. In Master-Slave operation one unit will act as
the controlling unit and the others will react to the
controlling units programs. Any unit can act as a Master or
as a Slave. Using standard XLR 2 core screened
microphone cables, daisy chain your units together via the
XLR connector on the rear of the units. Remember the
Male XLR connector is the input and the Female XLR
connector is the output. The first Triton scanner (master)
will use the female XLR connector only, the last use the
male XLR connector only and a terminator (see DMX
setting).
On the Master unit set your desired show with the mode (11) and Up/Down (13/14) buttons and set that show
by pressing the ENTER (12) button. On the slave units set the respective slave-mode for all slave devices. The
slave units will now follow the Master unit.
Please note
The function G-3 is only meant for service purposes. Please do only use this function if you want to set the unit
shortly into standby mode.