Skymsen TA-04MB-N, Инструкция по эксплуатации

Страница: 7 / 12

18
Table 02
PROBLEM CAUSES SOLUTIONS
- The blender does no switch
ON.
- Electricity shortage.
- Problem with the
blender electric circuit.
- Check electricity.
- Call technical assistance.
- Burning smell or smoke.
- Problem with the blender
electric Circuits.
- Call technical assistance.
- The blender starts, but a ft er
to place the ingredients inside
the cup , the blender rota
ti on
is too low.
- Problem with the motor. - Call technical assistance.
- Damaged cord. - Problem during transporta ti on. - Call technical assistance.
-Unusual noises. - Damaged bearing - Call technical assistance.
-The product does not
process.
- Product pieces too large do not
allow contact with the knife.
- Blunt knife.
- Cut smaller pieces about 3,5
cm.
- Call technical assistance.
- Cup is leaking. - Damaged seal. - Call technical assistance.
7
QUADRO 01
CARACTERÍSITCAS UNIDADE TA-04MB-N
Capacidade máxima do copo l 4
Voltage (*) V 110
Frequency Hz 50 / 60
Power Rati ng W 590
Consump ti on kW/h 0,59
Height mm 710
Width mm 270
Depth mm 240
Net Weight kg 4,6
Shipping Weight kg 5,7
1.3 Caracterís ti cas Técnicas
2. Installa ti on and Pre Opera ti on
2.1 Installa ti on
2.1.1 Placing
The Blender is to be installed onto a leveled surface approximately 850mm high.
2.1.2 Electrical Installa ti on
This equipment was developed to be used with: 110V. Upon receiving the Blender control
the voltage indicated on the cord label.
The cord has a plug with three pins one of them is grounding. It is mandatory the three
pins to be connected before to start to use the blender.