02
Picture - 01
01
02
03
05
07
08
04
06
1. Introduction
1.1
Safety
The High Performance Industrial Blenders are machines simple to use and to
clean. However for your safety read the following instructions in order to avoid
accidents:
1.1.1 Always unplug the machine when cleaning, servicing or when any other
operation is needed.
1.1.2 Never use tools that do not belong to the machine during operation.
1.1.3 Before using the machine check if Cup Nº02 (Pic.01) is properly fitted in
its position.
1.1.4 Never throw water directly to the machine.
1.1.5 Do not operate the machine wearing wet clothes or wet shoes.
1.1.6 Before operating the machine be sure it is grounded properly.
1.2
Main Components
All components are made with carefully selected materials, in accordance with
Siemsen experience and standard testing procedures.
01-
Lid
02-
Cup
03-
Cup Flange
04-
Motor Support Flange
05-
Motor Housing
06-
Base
07-
Voltage Selector Switch 110/220V
08-
On/Off Switch
07
4.1.3 Advices
In case of power shortage, immediately turn the machine OFF.
Use recommended or equivalent lubricants, oils or greases.
Avoid mechanical shocks as they may cause failures or malfunction.
Avoid penetration of water, dirt or dust into mechanical or electrical components
of the machine.
DO NOT modify original characteristics of the machine.
DO NOT remove, tear off or maculate any labels stuck on the machine. If any
label has been removed or is no longer legible, contact your nearest dealer for
replacement.
READ CAREFULLY AND WITH ATTENTION THE SAFETY OR OPERATION
INSTRUCTIONS LABELS DISPLAYED ON THE MACHINE, AS WELL AS THE
INSTRUCTION MANUAL AND THE TECHNICAL CHARACTERISTICS WRITTEN
INSIDE .
4.2 Safety Procedures and Notes Before Switching Machine ON
IMPORTANT
Carefully read ALL INSTRUCTIONS of this manual before turning the machine ON. Be
sure to be familiar with the instructions and that you have well understood all
information contained in this manual. If you have any question contact your supervisor
or your nearest Dealer.
4.2.1 Danger
An electric cable or electric wire with damaged jacket or bad insulation could
cause electrical shocks as well as electrical leak. Before use, check conditions of all
wires and cables.
4.2.2 Advices
Be sure ALL INSTRUCTIONS in this manual have been thoroughly understood.
Every function and operational procedure have to be very clear to the operator. Contact
your nearest Dealer for further questions.
Any manual command (switch, button or lever) shall be given only after being
sure it is the correct one.
4.2.3 Precautions
The electric cable has to be compatible with the power required by the
machine. Cables touching the floor or close to the machine need to be protected
against short circuits.
Oil reservoir has to be full up to the required level as indicated. Check level
and add oil if necessary.