14
Picture 11
4 – Place the product to be processed on the Movable Table;
5 – Adjust the side regulator (N°01 Picture 11) using its handle, unl the regulator has a
minimum space of 5mm from the product to be processed;
ATENTTION
Leave a minimum space of 5 mm between the Side Regulator (Item 01 Pic. 11) and
the product to be sliced.
ATENTTION
NEVER press or handle the product to be processed with your hands while the
equipment is turned on or in oper
a!on.
Place the Pusher (N°02 Picture 11) at the rear of the product to be processed;
6 – Use the Cut Regulator Handle to choose the desired thickness;
7 – Do all the procedure described on item 3.1 to begin the slicing operaon;
TIP:
You can adjust the slice thickness and the cung speed during the operaon.
01
02
23
5 – Use a so! cloth humidified with water and neutral soap to clean the sharpeners. To
return to the work posion proceed contrary to the sequence informed above.
- Cleaning the Equipment:
IMPORTANT
Do not use water jets/sprays directly on the Equipment.
Do not use water jets/sprays directly on the equipment, especially on the Control Panel
and the Safety Unit.
The equipment must be sanized with a so! cloth humidified with water and neutral soap.
A!er cleaning the equipment, it must be throughly dried with a thin flannel for be$er
results. To avoid scratches and marks do not use any kind of abrasive products, such as
sponges and thick cloths while performing the cleaning.
