Skymaster DCI 9410, Руководство по эксплуатации, Страница: 28 / 38

74
13. Settings
In the SETUP submenu SETTINGS, you can set the receiver time, the timer for automatic switching
on and off for up to 6 programmes, change the password and adjust the receiver settings to the
connected television set.
Time settings
You have 2 options for making time settings: “Automatic” and “Manual”.
You should usually use the “Automatic” setting, as the time settings are
already preset via satellite transmission. Select the time zone (Berlin for
Germany). Check that the time displayed under “Current time” is correct.
If necessary, switch the “Summertime” setting on or off.
Note: After switching on the receiver it can happen that incorrect times temporarily appear in the pro-
gramme information window or in the Programme Guide. The receiver needs a few seconds to load the
data sent by the satellite. If you only receive satellites that do not send additional time setting data, set the
time manually.
Timer
The timer function allows you to set the receiver so that it switches on and
off at defined times, or to switch on a set programme during another pro-
gramme. You can set up to 6 programmes with this function - no need to
miss them in future!
You can call up the timer menu directly (SETUP -> SETTINGS -> TIMER) or
transfer a programme from the Programme Guide (EPG): Press the EPG button, select a programme and
then the daily and weekly overview for the station (GREEN “Week” button). When you have found the right
programme, simply press the RED button (“Time”) to open the timer menu:
Timer no.: Select a free timer (1-6)
Programme: Select another programme if necessary
Setting:
OFF - no timer function • ON - timer activated
SINGLE - the timer function is only executed at the set time
DAILY - the timer function is executed daily at the set time
WEEKLY - the timer function is always executed on the same day of the week
DATE - Date of start time
START TIME - Entry of time (4-digit)
DURATION - Entry of programme duration/Film length (e.g. 90 minutes = 01:30)
Concluding information:
Before exiting the timer menu, make sure that the timer is activated (ON setting)! When entering film
lengths, you should also allow for overruns from previous programme times. If 2 timer programmings
overlap, you will receive an error message during entry!