Skymaster DCI 9410, Руководство по эксплуатации, Страница: 11 / 38

57
5. Remote control 4 in1
C. Setting up by Manual Search:
If setting up with brand name and codes is unsuccessful, you can also use the “Manual Search” to find
the correct code for operating your device.
1. Switch on the device that you like to control. If it is a video recorder, insert a video cassette.
2. Point the remote control at your device. Press down and hold the SET key and press the device key
(e.g. TV) in a short time (less than 3 seconds, otherwise it goes to Automatic Search), then release the
both pressed keys.
3. The device key lights up continuously and the remote control is then in setting-up mode.
4. Actuate the POWER key (ON/OFF key) about every 1.5 seconds. (If the device being sought is a video
recorder, etc., you may press the PLAY key also.), the device key now flashes, that means it is in
Manual Search mode.
5. Once the searched device switches off (or react), test the functions of other keys (don’t press POWER
key, in case it goes to next code) on the remote control. If most of them do not function properly, press
the POWER key about every 1.5 seconds again to call up the next reactive code (continues the Manual
Search, see step 4-5). If you feel most of keys on the remote control work good enough, you can save
the code by pressing the device key (e.g. TV) to finish the Manual Search.
Note:
The Manual Search will be automatically terminated if no entry within 30 seconds.
Other Functions
A. Display the Device Code:
The device code, which has been set up in your new remote control, can be called up as follows:
• Press the SET key and hold it down, now actuate number key “1” to display the 100th position of
3-digit code. Count the numbers the LED flashes. If the LED doesn’t flash, that means the digit is ZERO.
Similarly, press the SET key and hold it down, at the same time actuate number key “2” to display the
10th position of 3-digit code. Press the SET key and hold it down, at the same time actuate number
key “3” to display the 1st position of 3-digit code.
Example for Code 028:
a. Press SET and “1” LED flashes 0 time, no flashes.
b. Press SET and “2” LED flashes 2 times.
c. Press SET and “3” LED flashes 8 times.
B. Reset / delete function:
To delete the codes which have been set up in the remote control, press and hold down the SET key,
press the “0” key simultaneously for more than 3 seconds and then release the both pressed keys. The
LED will flash twice and all the set up data and all learn commands in the remote control are deleted.
Note:
Please don’t operate this function if you don’t want to delete all the settings.
C. Write-protection of Device Codes:
To protect the device codes from being inadvertently overwritten/deleted, you can carry out the following:
1. Press the device key (e.g. TV) that you would like to protect on your remote control.
2. Press and hold down the SET key and press the „7“ key at the same time. Then release the both
pressed keys, the LED will flash twice and the code is then protected from being overwritten/deleted.
Note:
To cancel write protection, press the SET key and hold it down, and activate the “8” key at the same
time, and then release the both pressed keys. The LED flashes twice and the protection have been
cancelled.