Skyjacker F4621A, Руководство по установке

Страница: 3 / 8

Hardware Bag Breakdown:
WS4320 Front Shocks
ITEM# DESCRIPTION qTY
WS4320S-17/32 WS430S,2 HOLES 1.574"CENTER 2
1204S 1/2 X 4 TIE BOLT W/NUT 4
12TBN 1/2" TIE BOLT NUT 4
HB-F460-BLE Brake-Line Extensions
ITEM# DESCRIPTION qTY
F460BLE-F BRAKE LINE BKT,FRONT 04F150 2
DVL10 DGE/FORD VAC/BRAKE BKT-FLAT 1
14X1FTB 1/4 X 1 FINE THD BOLT G8 3
14FTN 1/4-28 FINE N/I LOCK NUT 3
14SAEW 1/4 SAE WASHER 6
38CC 3/8" CABLE CLAMPS 2
5MMX12SHB 5MM X 12MM.80 KNUCKLE BOLTS 2
Note: F4621BSST box will not contain rear Add-A-Leafs or rear degree shims.
Front Installation
:
1.With the vehicle on flat level ground, set the emergency brake &
block the rear tires. Place a floor jack under the lower control arm’s
front cross member & raise the vehicle. Place jack stands under the
frame rails, behind the front wheel wells & lower the frame onto the
jack stands.
2. Remove the front tires / wheels using a 22mm socket. Remove the
brake caliper using a 13mm wrench. (See Photo # 1). It will not be
necessary to remove the brake line from the brake caliper. Simply
wire it out of the way until reassembly. Remove the brake rotor.
3. Disconnect the ABS line from the steering knuckle. Disconnect the
outer tie rod from the steering knuckle using a 21mm socket. It may
be necessary to strike the side of the knuckle to dislodge the tie rod
end. Be careful not to damage the tie rod itself.
5. Disconnect the upper & lower A-arm ball joint from the OEM steering
knuckle using a 21mm socket. (See Photo # 2) Remove the
steering knuckle.
I-F4621 Pg 3
Photo # 1
Photo # 2