Skyjack SJ 46AJ, Руководство по эксплуатации

Страница: 48 / 94

Page 48 December 2007
SJ 46AJ
Component Identification Operation - Section 3
3.6-5 Hydraulic Generator (If Equipped)
To start the hydraulic generator:
1. Ensure that engine is running.
2. On platform control console, turn generator on/
off switch to “
” on position.
To restore normal operation:
1. On platform control console, turn generator on/
off switch to “
” off position.
NOTE
An engine shut down will turn the generator
off. Normal boom functions are disabled
while the generator is on.
3.6-6 Welder (If Equipped)
The welder is installed on the platform. Refer to
welder’s operating manual for proper operation and
maintenance.
1
2
Figure 3-4. Welder
1. Welder - This equipment is plugged into its
dedicated AC outlet on the platform.
2. Welder AC Outlet - This AC outlet is dedicated
for the welder.
NOTE
In sub-zero temperatures, the hydraulic oil
should be warmed, prior to operating the
welder.
NOTE
This option adds 90 lb. (41 kg) to the
platform. This weight must be included
when determining the total load on the
platform, including personnel and other
materials.
WARNING
Only qualified persons should install,
operate, maintain and repair the welder.
CAUTION
Breathing welding fumes and gases can
be hazardous to your health.
3.6-7 Arctic Weather Package (If Equipped)
The heater plug is located on the engine compartment
near the battery.
1
Figure 3-5. Heater Plug
1. Battery/Hydraulic Oil/Engine Oil Heater Plug -
This cord is plugged into the AC outlet at least 3
hours before starting engine when temperature
gets below -18°C (0°F).