TM
Page 80
December 2007
SJ 46A & SJ 46AJ
Labels
Section 2 - Operation
No.
Label Pictorial
Description
6
Read operating manual for full explanation of these hazards.
Other Hazards
* Do not operate if aerial platform is not working properly or if any
parts are damaged or worn.
* Do not exceed rated load or distribute load unevenly at any time.
* Do not alter or disable limit switches, safety switches or interlocks.
* Do not leave aerial platform unattended with key in key switch.
* Do not raise platform while aerial platform is on truck, fork lift or
other device or vehicle.
* Do not use under influence of alcohol or drugs.
* Do not use with improperly inflated/damaged tires or wheels.
Tires should be checked daily for pressure, torn side walls
and soft spots.
* Do not use without guardrails and entry gate in place.
* Do not operate without safety harness and lanyard properly
attached.
Failure to operate this equipment in accordance with operating instructions on this
equipment and in operating manual could result in death or serious injury!
A
143511AD
Use only original replacement parts. Parts such as
batteries, chargers, wheels, railings, etc. with weight and
dimensions different from original parts will affect stability
of aerial platform and must not be used without
manufacturer's consent.
Do not operate aerial platform without proper authorization and training.
It is operator's responsibility to:
* Read and completely understand all Dangers, Warnings, Cautions and
Instructions on aerial platform and in operating manual.
* Ensure that aerial platform has been properly maintained and inspected
in accordance with government regulations before using it.
* Perform all daily maintenance inspections.
WARNING
Electrocution Hazard
Failure to avoid these hazards will result in death or serious injury!
Avoid soft,
uneven
surfaces.
Avoid slopes.
Do not
release
brake
on incline.
Avoid
entanglement
with ropes,
cords or
hoses.
Avoid
falling.
Do not wear
jewelry or
loose
clothing.
3
9
6
21
Avoid
overhead
obstructions.
Avoid
drop-offs.
Ladders,
scaffolding
prohibited.
Do not
use as
a crane.
It is
prohibited.
Avoid
lowering
obstructions.
Do not lift
the chassis.
Do not raise
while on a
truck or
other
devices or
vehicle.
Avoid
side
forces.
Avoid
crushing
hazards.
Be aware
of blind
spots.
Stay off
guardrails
and boom
arms. It is
prohibited.
Avoid
lightning
and storms.
Avoid wind.
Do not
increase
lateral
surface area.
Avoid
power
lines.
As per CSA B354.4-02
“The operator shall maintain the minimum safe approach distance
from
energized conductors at all times in accordance with the authority having jurisdiction.”
(MSAD)
Per ANSI A92.5-2006 8.10(7)
“The operator shall perform only that work for which he or she is qualified, in
compliance with all applicable safety related work practices intended to prevent
electric shock covered by the Code of Federal Regulations (CFR) 1910.333. The
operator's level of competence shall be established only by persons qualified to do
so. Operators shall maintain the appropriate minimum approach distance
from energized power lines and parts covered by CFR 1910.333 (c).”Unqualified
persons must maintain a minimum approach distance of 10 feet from any energized
power line up to 50 kV. Energized power lines over 50 kV require a greater minimum
approach distance to be maintained. Refer to CFR 1910.333.
(MAD)
As per AS 2550.1-2002
Elevating Work Platforms must remain 6.4m from electrical distribution lines up
t
o
133kV and 8m from transmission lines greater than 133kV. State regulations may
take precedence over these approach distances.
This aerial platform is not electrically insulated.
must allow
This aerial platform does not provide
protection from contact with or proximity to an electrically
charged conductor.
Maintain a
Minimum Safe Approach Distance (MSAD) from energized power
lines and parts as listed below. The operator
for the
platform to sway, rock or sag.
DANGER
Hazard Identification
Read and understand outlined risks associated with this work
platform prior to operation.
7
AWPT “Click It!”
(ANSI/CSA)
Indicates full body harness awareness.
8
J
S
6
4 AJ
Model Number*
Product Identifier - blue
*Model number will vary, may not be as shown.
9
Horizontal Load Rating
Apply no more than indicated side load. Operate below indicated
wind speed only.
10
Skyjack Logo
Small Skyjack logo - blue
Platform (Continued)
2
1
1
3
4
2
5
8
10
6
9
7
