![Skyetek SkyeModule Nova Скачать руководство пользователя страница 17](http://html1.mh-extra.com/html/skyetek/skyemodule-nova/skyemodule-nova_user-manual_1290295017.webp)
SkyeModule Nova Datasheet
-
Preliminary
Page
|
17
Skyetek Inc
1415 Larimer Street, Suite 207
Denver, CO 80202
www.skyetek.com
Main 720.328.3425 Fax:720.228.2400
8
System Performance
8.1
System Range
The range measurements below should be used as a guideline and not a guarantee. Environment can play a major
role on tag range performance. Be sure to avoid any conductor in or near the field, as eddy currents can
significantly reduce energy transfer between the reader antenna and the tag.
Measured Range with 6dBi Broad Band Antenna
Min
Typ
Max
Units/Notes
Avery Dennison Label, Monza 3 Chip
6
10
m
Figure 8-1: Range Measurements
9
Regulatory Approvals and Module Integration Guidelines
9.1
Agency Approvals
The SkyeModule Nova has been approved for use in the following regions:
Region
Applicable Rule
Identifier
Notes
USA
FCC 15.247
WZ4-NOVA001
Modular Approval
Canada
IC RSS 210-ANNEX 8
5893A-NOVA001
Modular Approval
EU
ETSI 302 208-1
9.2
FCC/IC Guidelines (English)
The SkyeModule Nova module is provided with FCC and Industry Canada Modular Certification. This means that
the module meets the intentional radiator emissions requirements of the FCC Part 15 and IC RSS-210 and the
module integrator is not required to perform further testing, provided the following guidelines are met.
An approved antenna is directly coupled to a Nova antenna port. If a different antenna of the same type is
used, it must have the same or less gain than the approved antenna. A listing of approved antennas is
shown below.
End product must be externally labeled with “Contains FCC ID:
WZ4-NOVA001 and IC: 5893A-NOVA001
”
The end products user’s manual must contain an FCC statement equivalent to that listed below in section
9.2.1
The end product must not provide any information regarding installation, removal or modification of the
module.
9.2.1
Information to the User
The following information must be included in the end product’s user manual: