19
Flips & Tricks
Before attempting any stunts, be sure that there is ample clear space around the
craft, ideally 9 to 10 ft. in every direction. It is not recommended to attempt to flip
around or through any obstacles, as this may result in unintended damage.
Headless Mode
Headless Mode disables the default orientation of the craft, where the green LEDs
indicate the front of the craft. Instead, the craft will reorient its “front” based on the first
Right Control Stick input from the user. This can be useful if you become disoriented
while flying, or cannot visually determine which direction is “true front”.
To activate Headless Mode, press down (into the body of the remote control) on the
Left Control Stick. Press again to deactivate Headless Mode. A chime will sound both
times to indicate when Headless Mode is active or inactive.
Altitude Hold/Hover
The Condor Pro automatically hovers at any altitude set by the user, simply push the
Left Control Stick/throttle up or down to reach the desired altitude, then release the
stick. The craft will hold that altitude until adjusted again by the user. This can be useful
for flying and operating the camera controls at the same time.
Note: The craft will may shift in altitude within a range of approximately 8-12
inches. Bear this in mind while flying and performing precise maneuvers.
Craft will perform flip
in the desired direction.
Press and hold the Flip button, then move the Right
Control Stick in any direction.
