Sky Climber Compact 1000, Инструкция оператора

Страница: 14 / 29

January 2019 Page 14

Exit guide must be clear. Wire rope must run freely away from the hoist.

Guide hoist as it climbs up to the stirrup level.

Attach hoist to Suspended Platform Stirrup.

Insert hoist stirrup strap into platform stirrup recess.

Use either Grade 5 nuts/bolts or shoulder bolts and nuts provided by manufacturer.

Tighten nuts securely.

Make sure wire rope exits outward, away from platform’s work area.

Assemble Sky Lock Hoist with Coupling Link.
Coupling Link must provide clearance for straight passage of wire rope.

Remove Coupling Link from storage box.

Line up Coupling Link with hole in the top of Hoist.

Attach with shoulder bolt. Tighten nut securely.

Slide Sky Lock up one inch, then turn Sky Lock Reset Lever clockwise to open jaws, letting
Sky Lock slide down wire rope.

Line up hole in Sky Lock with the top of the Coupling Link.

Attach shoulder bolt. Tighten nut securely.

Secure Wire Rope End.

Limit wire rope bitter end to a few feet. Store excess wire rope at top on suspension end.

Test Hoist Load.

Place load equal to weight of workers, tools and materials on one end of the platform. Have
co-worker check rigging for slippage/malfunction during the test.

Inspect all rigging/platform connections. Tighten or adjust as needed.

Select Hoist Directional Switch UP direction to raise the platform 6 inches off surface.

Turn Manual Trip Lever counterclockwise to set the Sky Lock Brake.

Select Hoist Directional Switch DOWN direction. System should not descend.
Wire rope will loop out between the top of the hoist and the bottom of the Sky Lock.

Select Hoist Directional Switch in the UP direction to take up the loop and raise the platform
one inch to relieve the load from Sky Lock Jaws.

Turn Sky Lock Reset Handle clockwise to reset Sky Lock.

Repeat procedure twice.

Repeat the same hoist load test procedure at the other end of the platform.

If hoist or Sky Lock fails test, return failed unit to Factory Authorized Service Center.

Test Emergency Stop Button.

Select Hoist Directional Switch in the UP direction to raise platform 6 inches . While
ascending, press the Emergency Stop Button. Power should stop to hoist and primary brake
should engage.

Turn Emergency Stop Button Switch clockwise to reset.

Repeat test.

If Emergency Stop fails, return hoist to Factory Authorized Service Center.
!
WARNING
Serious injury or property damage may result from falling
objects during hoist load test. Be alert and prepared to quickly
move from the likely impact zone.