39
SKOPE TME650/1000
Replacement Procedures
Service Manual
Evaporator
Fan
The evaporator fan is fixed to the evaporator fan mounting plate, mounted
on the evaporator coil inside the evaporator box.
To remove and replace the evaporator fan blade
To remove and replace the evaporator fan
1. Disconnect the chiller from the power supply.
2. Remove the evaporator box assembly lid to access the interior of the
evaporator box.
3. Unscrew the evaporator
fan mounting plate fixing
screws and lift out and
up from the unit.
Note:
The mounting
plate has a tab slot at the
base of it.
4. Remove and replace the fan blade.
5. Reassemble and refit the refrigeration unit.
1. Remove the fan assembly and fan blade (see steps 1 - 4 above).
2. Open the unit junction
box (see page 36). Trace
the evaporator fan flex to
the unit junction box and
detatch the evaporator
fan wires. Withdraw the
flex from the unit junction
box
3. Remove the fan blade and the perimeter screws from around the fan motor
to detach it from the mounting plate.
4. Fit the replacement fan motor to the mounting plate, refit the fan blade and
refit the assembly to the shroud. Replacements do not require
reprogramming as the speed is already set at the factory.
5. Feed the condenser fan flex through to the unit junction box and reattach
the wires. Refer to the wiring diagram (page 10) for wiring details.
6. Close the unit junction box and refit the refrigeration unit.
