Skope BME1200-AC, Руководство пользователя

Страница: 18 / 20

18
Servicing
User Manual
SKOPE BME ActiveCore
Lighting
This chiller is designed for use with LED tube lights and is not compatible
with fluorescent tubes.
LED Tube Side
Lighting
LED tube side lit cabinets are lit by one or two T8 LED tube side lights, which
can be replaced without moving shelves or product. See the table below for
light tube specifications.
Interior light tube specifications
To replace an LED tube side light
LED Modular
Shelf and Side
Lighting
Cabinets with LED modular shelf and side lighting are lit by LED shelf lights
mounted on the front of the shelves (two lights per shelf), and LED side
lights. LED modular light components are all non-serviceable items and
must not be tampered with in any way. If a component is suspected of being
faulty, a service call should be arranged so that a replacement component
can be fitted.
Sign Light
BME600-AC and BME1200-AC chillers are fitted with a lit sign. In the event
of sign light failure, a service call should be arranged so that a replacement
LED tube can be fitted.
IMPORTANT
DO NOT use fluorescent tubes.
Item Description
Interior light Eco-Point 20 Watt T8 LED tube (Ø26mm x1350mm)
1. Remove the front kick panel and isolate the chiller from the power supply (see
page 15).
2. Remove the diffuser by
squeezing it until it is
released from the
aluminium housing, and
then push the diffuser out of
the way.
3. Rotate the LED tube until
the pins on the ends of the
tube align with the slots,
then slide it out.
4. Fit a new LED tube. Ensure
the LED tube is fitted with
the ‘Power’ end at the top
(usually marked ‘POWER’
or similar).
Note: If present,
the pointer at each end of
the tube should be set to
the “0” position.
5. Refit the diffuser by slipping the back section into the housing, then squeezing
and snapping the front section of the diffuser into place as you work down the
length of the light.
Diffuser
LED Tube
Pins
LED tube
Lamp holder