Skoda 6V0 063 218, Инструкция по монтажу

Страница: 5 / 60

EN
5
SmartGate control unit
The accessories are intended for professional fitting. ŠKODA AUTO recommends that they are
fitted by a contractual partner.
Component index for the set (fig. 1)
Component Quantity Item
Control unit 1 A
SmartGate wiring harness 1 B
2-pin connector (sleeve connector) 1 C
6-pin connector (sleeve connector) 1 D
Damping piece 1 E
Cable ties 8 F
Mounting instructions 1
Mounting procedure
When fitting the components, the vehicle battery should be disconnected (in vehicles with a
coded radio, first request the code).
The individual components are removed and refitted according to the instructions in the
ŠKODA repair manual.
Remove the following components:
› The interior sill trim (on the driver's side),
› The lower A-pillar trim panel (on the driver's side).
Loosen the following components:
› Retaining bracket,
› Central control unit.
Fig. 2
› The connection diagram for the SmartGate wiring harness (B) – hereafter simply referred
to as the wiring harness (B).
Fig. 3
› Move the driver's seat backwards.
› Guide the wiring harness (B) under and out from the driver's seat (between the floor cover-
ing and the damping piece), past the ridge on the seat-adjustment mechanism and through
to the vehicle's existing electrical installation that is routed on the door sill.
› Guide the wiring harness parallel to the vehicle's existing electrical installation to the lower
A-pillar.
Note. Carefully route the wiring harness (B) and use the cable ties (F)
to secure it to the vehicle's existing electrical installation roughly in
the area shown in the figure.
Fig. 4
› Plug the wiring harness connector (B) into the control unit (A).
› Stick the control unit below the driver's seat in the area shown in the figure (using the
hook-and-loop fastener that is located on the underside of the control unit).
Note. When fitting the control unit, always check the firmware
version. Update any old firmware.