Skipper DL1-Multi, Руководство по установке

Страница: 10 / 25

Page 18 of 48
Date: 2021-12-10
Date: 20121-10-10
Page 19 of 48
InMan DL1-Multi Single Axis Doppler Speed Log System
InMan DL1-Multi Single Axis Doppler Speed Log System
Electronics AS
Electronics AS
Color Code Signal Screen Color Code Pair Screen
White +18-36 V DC
Individually
screened pair
Brown / White (blue) Pair
Common screen
Black 0 V Blue (brown) / Blue (white) Pair
Yellow TX+
Individually
screened pair
White (green)
Pair
Black TX- Green (white)
White RX+
Individually
screened pair
White (orange)
Pair
Orange RX- Orange (white)
Yellow Aux+
Individually
screened pair
N/A
Pair
Orange Aux- N/A
To be grounded
together and
passed into the
outer screen of the
Cat5e cable
The JuncTion BoX
JB12,
anD caBLe eXTensions
Sensor cable
Extension cable
Colour Description (seen
from JB70XX)
Screen Colour (for CAT6)
White +18 - 36 V DC Individually screened pair Common screen Brown Pair
Black 0 V White(Brown)
Orange RX+ Individually screened pair Orange Pair
White RX- White(Orange)
Black TX+ Individually screened pair Green Pair
Yellow TX- White(Green)
Orange AUX+ Individually screened pair N/A Pair
Yellow AUX- N/A
All individual screens to be grounded together and
passed into the outer screen of the CAT5e cable
Outer shield
Connect the sensor cable
to the Extension cable as
shown. All grounds are
collected together and
connected to the outer
ground of the Extension
cable. The grounds should
not be connected to a local
ground. If there is no room
for the JB12 housing, the
cables can be carefully
spliced together. Both cables
can be cut.
C
able diagram
Cd402XX-SC
Signals Pin number on
plugable WAGO
back connector
+24 V 1
0 V 2
NMEA IN A 3
NMEA IN B 4
DIM UP A 5
DIM UP B 6
DIM DWN A 7
DIM DWN B 8
NMEA2 IN A * 9
NMEA2 IN B * 10
NMEA1 OUT A 11
NMEA1 OUT B 12
Note: NMEA in/out is not in use on
LAN set up.
Wago
connector
LAN
connector
cD402 c
onTroL uniT To
e
LecTronic uniT
The CD402XX-SC is powered by local 24VDC on pin 1 and 2 on Wago connector.
Connection to Electronic with LAN connector directly or via LAN switch.
Alternativ 2
Connect CD402 Control unit to JB70D1 via LAN switch
Alternative 1
Connect CD402 Control unit to JB70D1 directly.