SKIMO – AIR CONDITIONING UNIT
CODE PRODUIT : 320B12 / 320B17
INSTALLATION, USER AND MAINTENANCE MANUAL
Page 9/22
10. ELECTRICAL CONNECTION
There are two possible ways to lay out the electrical cables:
-
Inside the cabin (recommended), through one of the cabin frame post for example.
-
Outside the cabin.
In both cases the installer must make sure that the cables are insulated and protected from any risk
of deterioration or tear-up (from branches for example) and that they do not present any risk for people or
appliances.
10.a Case of the cables being laid out inside the cabin:
1. Remove the grommet at the bottom
of the black evaporator casing
2. make a hole in the grommet and
insert the cables through it.
3. Insert the cables in the hole from
which you removed the grommet, ease
them out inside the cabin through the
unit air intake cut out, and set the
grommet back in place. Make sure the
grommet is waterproof
10.b Case of the cables being laid out outside the cabin:
Make a hole on the white outer Skimo casing (the lower part), lay the cable out through this hole with a grommet.
Do not lay the cables out near the motor and compressor belt located at the back of the unit.
1. Once the cables laid out, plug the 4 ways Deutsch connector.
2. Connect the 80V cables to the battery, and the accessories power cables to the suitable voltage source (+12V / +24V).