SKIMO – AIR CONDITIONING UNIT
CODE PRODUIT : 320B12 / 320B17
INSTALLATION, USER AND MAINTENANCE MANUAL
Page 7/22
6. FURNITURE REQUIRED TO INSTALL SKIMO
x
×4 cables of 2 mm
2
section each to connect SKIMO to the vehicle’s battery: a black one for the ground and a red
one for the positive power supply of accessories (12VDC or 24VDC) and two for the power supply of the
compressor motor. Cables used for 80VDC voltage must be H07-VK or H07-VR
marked. These cables must be ended by a 4 contacts Deutsch sealed
connector, as following:
1
Æ
+80VDC
2
Æ
GND (relative to +80VDC)
3
Æ
+12V or +24V (accessories power source)
4
Æ
GND (relative to accessories power source)
Caution: Maximum cable length: 5 m
x
One 1 mm
2
diameter cable to connect SKIMO to the +12V/+24V ENABLE signal (contact, auto-off system…),
with a 2 ways FASTON connector (male housing, female contact).
x
A fuse holder and a 20Amps for the 80V power source.
The above mentioned components are available as a connection optional set, reference
274B95
x
A silicone tube to seal the Skimo A/C unit on the vehicle’s roof
7. PREPARATION OF THE SKIMO A/C UNIT
Remove the 4 unit fastening screws circled in blue
Caution! Do not unscrew the 4 screws at the back of the unit
8. CABIN ROOF PREPARATION
Caution: Wear appropriate
protection according to the method and
tools used to cut-out and drill the roof
(Protective gloves, glasses, ear plugs…)
1. Place the template on the roof. (See
cut-out drawing below and template in
appendix)
2. Cut out and drill the roof following
the template