95
When reinstalling belt guard, position its cut-away toward front of
snowmobile. Refer to decal in belt guard.
Place belt guard in rear slots first, then snap front part in retainer.
TYPICAL
1. Slots
NOTE:
Belt guard is purposely made slightly oversize to maintain ten-
sion on its pins and retainers preventing undue noise and vibration.
It is important that this tension be maintained when reinstalling.
Drive Belt Removal/Installation
NOTE:
Removal and installation of drive belt is easier when driven
pulley is held with brake so that it can not rotate. Apply parking brake,
for this purpose.
Turn off engine cut-out switch.
Open left hand side panel and remove belt guard.
1
A33D0AA
Mmo2002-006b.book Page 95 Thursday, November 29, 2001 2:31 PM
Содержание MX Z 800 2145 2002
