Ski-Doo MX Z 800 2145 2002, Руководство оператора

Страница: 79 / 123

77
PRE-OPERATION CHECK
• Remove snow and ice from body including seat, footrests, lights,
controls and instruments.
• Verify that track and idler wheels are unfrozen and free to turn.
• Activate the brake control lever and make sure the brake fully ap-
plies before the brake control lever touches the handlebar grip. It
must fully return when released.
• Check the parking device. Apply parking brake and check if it op-
erates properly.
• Activate the throttle control lever several times to check that it
operates easily and smoothly.
• Check operation of tether and engine cut-out switches, headlight
switch (HI-LO), taillight, brake light and indicator lights.
• Verify that skis and steering operate freely. Check corresponding
action of skis versus handlebar.
• Check fuel and injection oil for levels and leaks. Replenish as nec-
essary and see an SKI-DOO authorized dealer in case of any leaks.
• Open or close heated carburetor valve according to outside tem-
perature.
• Verify that air filter(s) is free of snow, if so equipped.

WARNING
The pre-operation check is very important prior to operating
the vehicle. Always check the proper operation of critical con-
trols, safety features and mechanical components before start-
ing. If not done as specified here, severe injury or death might
occur.

WARNING
Always use a wide base mechanical snowmobile stand to
properly support vehicle during any track verification. Slowly
accelerate engine in order to rotate track at very low speed
when it is not on ground.

WARNING
Throttle lever must operate easily and smoothly. It must re-
turn to idle position when released.
Mmo2002-006b.book Page 77 Thursday, November 29, 2001 2:31 PM