Sixty Four Pixels Arpie, Руководство пользователя

Страница: 40 / 40

With other types of programmer, you’ll need to connect the individual pins of the
programmer to corresponding pins on the header, using the provided jumper cables
as follows
Arpie Pin Connected Programmer Pin
1 Reset Reset / RST or leave unconnected
2 TX (Transmit) RX (crossed over)
3 RX (Receive)
TX (crossed over)
4 +5V +5V / VCC / VDD
5 GND GND
6 GND Leave unconnected
The pin 1 end of the connector on the Arpie board is indicated with a digit “1”. It
might be necessary to take out the screws and remove the top Arpie PCB to access
the programming header. The control surface does not need to be attached during
programming.
Disconnect all MIDI connections during programming and make sure that the Arpie
is powered via battery or DC socket and is switched on (it might look powered up as
soon as USB is connected but you MUST power Arpie normally and make sure it is
switched on during programming)
Open the firmware file in Arduino (you will get prompted that the code has been
placed automatically in an “ Arpie ” folder)
In the Arduino environment, select the COM port for the programmer (which is
usually the highest numbered port and appears only when the programmer is
attached) and select Board Type “Arduino Duemilanova” and processor type
“ATMega 328”
Press Ctrl-U to compile the code and upload to the Arpie. Compilation takes a few
seconds - get ready to press the reset button on the Arpie
… as soon as the message
on the Arduino status bar changes from “Compiling” to “Uploading”, press the reset
button on the Arpie board. Within 10- 15 seconds you should have a “Done” message
in the Arduino environment status bar and the Arpie has been updated.
You can check the firmware version installed on an Arpie by holding the HOLD
button while the device boots up as described previously.
Disconnect the programmer from the header before reattaching the MIDI cables.
For troubleshooting information please check https://six4pix.net/product/Arpie/#tab-
diagnostics-faq