sitrex SR 320/8 H, Использование и обслуживание списка запасных частей

Страница: 6 / 42

6
24- Before connecting or disconnecting the machine to or from the 3-point linkage, put the lifting unit lever
into the locked position.
25- The connection pins on the machine must match the connection sockets on the lifting unit.
26- During transport, secure the lateral lifting arms with the appropriate chains and tighteners.
27- When the machine is raised during road transport, put the tractor's hydraulic lifter lever into the locked
position.
28- Only use the Cardan shaft provided by the manufacturer and, in case of replacement, substitute it with
one having the same characteristics.
29- Regularly check all protection on the Cardan shaft. This should always be in excellent condition and
securely fixed.
30- It is important to ensure that the protection on the Cardan shaft is complete.
31- Connection and disconnection of the Cardan shaft must be carried out with the engine switched off.
32- Pay particular attention to the correct connection and safety of the Cardan shaft and the power takeoffs
on the machine and the tractor.
33- Prevent the cardan shaft protection from rotating using the chains supplied.
34- Before engaging the power takeoff, make sure that there are no people or animals in the vicinity and that
the selected engine speed corresponds to that permitted. Never go above the maximum permitted.
35- Do not engage the power takeoff when the engine is not running.
36- Always disengage the power takeoff when the Cardan shaft
is at too wide an angle (it should never be more than 35° see
fig) and when it is not in use.
37- Only clean and grease the Cardan shaft when the power
takeoff is disengaged, the engine is off, the parking brake is
applied and the ignition key is removed.
38- On disconnecting the Cardan shaft, replace the protective
hood on the power takeoff shaft.
39- Prolonged use of the machine can cause the drive boxes to
become hot. To avoid any risk of getting burnt, avoid touching
these areas both during use and some time afterwards.
40- Periodically check screws and nuts for tightness and grip.
Tighten if necessary.
41- When carrying out maintenance work or replacing the blades, raise the machine and rest on adequate
supports.
42- Use the quantities of grease and oil advised.
43- Spare parts must meet the requirements as defined by the manufacturer. Use only original spare parts.
44- Safety decals must always be clearly visible. They must be kept clean and replaced if they become too
illegible (they can be ordered from the agent if necessary).
45- The instruction booklet must be available for the lifetime of the machine.